-

Amplifier Wattage vs Speaker Wattage
Match an amplifier to passive speakers with confidence: compare continuous ratings at the right impedance, leave headroom, avoid clipping and set gain so the…
-

What Is a DSP Amplifier?
What a DSP amplifier adds to a distributed audio system: speaker EQ presets, high-pass filters, limiters, delay and routing for ceiling and outdoor zones,…
-

How to Paint Speaker Grilles
Paint in-ceiling and in-wall speaker grilles without losing sound: remove the grille and scrim, prime the metal, spray thin coats, keep every perforation clear…
-

In Wall Volume Control Buzzing: Causes and Fixes
Why an in-wall volume control buzzes or hums, and how to fix it: transformer vibration on bass, the impedance setting, loose plates and brackets,…
-

OEM vs Compatible Projector Lamp
Original, original inside or compatible? How projector lamp types differ in bulb, housing, brightness and life, what US warranty law says about aftermarket lamps,…
-

Soundbar Subwoofer Placement
Where to put a soundbar’s subwoofer: corner or front wall, why room modes change the bass, how to do a sub crawl, which settings…
-

Subwoofer Cable vs RCA Cable
Is a subwoofer cable different from an RCA cable? What the label changes, when an ordinary lead works, how to handle long and in-wall…
-

2 Post vs 4 Post Rack
Choosing between a 2 post and 4 post rack: how each carries equipment, depth and rails, centre mounting, floor anchoring and seismic bracing, cable…
-

How to Mount a TV Without Studs
Studs in the wrong place, made of steel or missing? How to mount a TV without studs using wide plates, toggles, steel stud kits,…
-

Amplifier Going Into Protect Mode? Fix It
Why a multi-zone or 70V amplifier goes into protect mode and the order to find the cause: shorted speaker runs, too low a load,…
-

Do In Ceiling Speakers Need Back Boxes?
When an in-ceiling speaker needs a back box and when it does not: bass consistency, sound between floors, attic insulation, fire-rated ceilings, and the…
-

How to Fix Ground Loop Hum
Track down the hum in an AV system: unplug sources one at a time, fix cable TV coax loops with an isolator, use audio…